Combat Monkey Build Wingspan 750mm Laser cut 5mm Foam Board $15 The kit includes: Foamboard airframe components Ply and popsicle sticks for the motor mount. Corflute fuselage underside What you need to complete: 3 x 9g Mini Servos HXT900, MG90 etc Motor 2830 1200 kv to 2836 1500 kv 8x6 Prop (folding is better) 1300mah 3 cell lipo 30 amp ESC with BEC Sticky tape for hinges 3 control horns and 1.6mm piano wire 4ch RX Paper Party Streamers about 40mm wide and at least 5m long Tools: Hot Glue Gun and Sticks Box Cutter Scrape pieces of foam board to wipe off excess glue. Z bender Build With a sharp blade release all the foam board components from the backing sheet. Carefully deepen the hinge lines on the ailerons and elevator without cutting right through then bend back to form a hinge. If you cut through, just tape the component back in place with clear sticky tape. Bevel the rearward side of the hinge surfaces forty-five degrees